CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE MADE IN ACCORDANCE
WITH LOCAL CODES, ORDINANCES, OR NATIONAL ELECTRICAL CODE. IF YOU ARE
UNFAMILIAR WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE THE
SERVICES OF A QUALIFIED ELECTRICIAN.
1. Run wiring from wall switches carrying the appropriate rating. One neutral (white), one
ground (green or bare copper), and three hot (red, blue, and yellow leads connected to
the switch, one for each function). Secure the electrical wires to the housing with an
approved electrical connector. Make sure you leave enough wiring in the box to make the
connection to the fan’s receptacles.
2. Connect the White wire from the house to the three White wires from the fan. Connect one
Hot (Blue) wire from the wall switch to the Blue wire from the fan (this is the fan control).
Connect second Hot (Red) wire from the wall switch to the Red wire from the fan (this is
the heat control). Connect the third Hot (Yellow) wire from the wall switch to the Yellow
wire from the fan (this is the light control). Connect the ground wire from the house to the
Green wire from the fan (Figure 7). Use approved methods for all connections.
SECTION 6
Completing the Installation
1. Reinstall the fan’s venturi by holding it at approximately a 45 degree angle, hook the two
tabs on the venturi into the slots on the housing and secure in place by tightening the
venturi screw. Rotate the blower wheel by hand to ensure it spins freely (Figure 8).
2. Insert the plug from the heating unit into the receptacle marked “HEAT”, and the plug
from the fan into the receptacle marked “VENT”(Figure 9).
www.airkinglimited.com
210575055 Rev. F 5-14 3 of 12
3. Remove grill from carton and open light lens area by pushing in on the two tabs of the
light lens and pulling outward from lens. The lens will swing open on the connector bars.
DO NOT remove the lens from the grill (Figure 10).
4. Install light reflector into grill by lining up the posts on grill with the holes in light reflector
(Figure 11). Raise light reflector and grill up to housing and insert plug from light into
receptacle marked “LIGHT” (Figure 9).
5. Attach light reflector in place with the two nuts removed during Step 2 in SECTION 1
Preparing the Unit so grill fits snuggly against ceiling (Figure 12).
Supply from house
Figure 7
Ground
Hot (Blue)
Hot (Yellow)
Hot (Red)
Neutral (White)
Figure 8
Heater
Figure 9
Vent
Connector
Bar
Tabs
Figure 10
Post
Hole
Post
Figure 11
Nut
Figure 12
(12 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern